Whirlpool builds many of the washers in Greer homes, including Maytag, Amana and many Kenmore models. Tyger River Appliance repairs Whirlpool top load and front load washers across Greer, Taylors, Duncan, Lyman, Wellford, Reidville and Pelham. Call (864) 428-6288 Monday to Friday, 8am to 6pm.
Whirlpool washer problems by symptom
Lid lock light flashing, won't start. On top loaders the lid lock assembly is one of the most frequent failures. The washer will not agitate or spin until the lid locks.
Won't spin or agitate but the motor hums. On direct drive top loaders a broken motor coupler is classic. On newer models the shift actuator or drive belt is often involved.
Won't drain. A clogged drain pump or a small item caught in the pump. On front loaders, a clogged filter or failed pump.
Long fill or no fill. Clogged inlet screens or a failed water inlet valve, often shown as F8E1.
Banging during spin. Worn suspension rods or a failed tub dampening strap on top loaders.
Whirlpool washer error codes we see most
- F5E2 / F5E3: lid lock or door lock fault.
- F8E1 / Lo FL: long fill, water supply or inlet valve problem.
- F9E1 / Lo dr / Sd: long drain, clogged pump or hose, or excessive suds.
- F7E1 / F7E5: motor or shifter fault.
- F1E1 / F0E2: control board fault or overload condition.
- F5E1: door switch fault on front loaders.
- uL / UL: unbalanced load.
When to call for Whirlpool washer repair
Call if the lid lock light keeps flashing after you close the lid firmly, if F8E1 or F9E1 returns after checking hoses, if the washer hums but does not move, or if it bangs during spin.
Greer water and detergent
Greer's soft city water means Whirlpool HE washers rarely suffer heavy scale, but too much detergent creates suds that slow draining and can trigger Sd and F9E1. Use the HE dose shown on the bottle for the load size.
Repair or replace a Whirlpool washer?
Lid locks, couplers, pumps, inlet valves and actuators are usually affordable repairs. A failed transmission or outer tub on an older machine may make replacement the better call.
Technician insight
On older Whirlpool direct drive top loaders, a washer that fills and drains but will not agitate or spin is very often a broken motor coupler, a small and inexpensive part.
Whirlpool Washer Repair Services We Offer
✓Whirlpool Lid and Door Lock Repair
Fixing F5E2 codes and lid lock lights that stop the cycle.
✓Whirlpool Coupler and Actuator Repair
Restoring spin and agitation when the motor hums but nothing moves.
✓Whirlpool Drain Pump Repair
Clearing and replacing pumps behind F9E1 long drain codes.
✓Whirlpool Inlet Valve Repair
Fixing F8E1 long fill problems.
✓Maytag and Kenmore Washer Repair
Repairing Whirlpool-built Maytag, Amana and Kenmore washers.
How it works
- 1
Call and describe the problem
Call (864) 428-6288 Monday to Friday with the model number and any code.
- 2
Diagnosis in your home
The washer is run in diagnostic mode and the failed part tested.
- 3
Clear quote, then repair
You hear what failed before any work starts.
- 4
Test cycle
A full cycle confirms the washer fills, agitates, drains and spins.